LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 178 (5.2L V8 Gas - VIN [Y]) >> Overhaul >> Cylinder Block Assembly >> Cylinder Block

Cylinder Block

WARNING: This page is about a different car, the 1995 Jeep Grand Cherokee, 1995 Dodge Ram Wagon, 1995 Dodge Ram Van, 1995 Dodge Pickup, and 1995 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check cylinder bore, out-of-round and taper. Measure cylinder bore diameter below top surface of cylinder bore, middle of bore and bottom of cylinder bore. Bore cylinder block if bore diameter is not within specification. See CYLINDER BLOCK  table under ENGINE SPECIFICATIONS.
    NOTE: Cylinder bore should be measured at room temperature of 70°F (21°C).
  2. Check valve lifter bore diameter. Check for scoring. If scoring exists or lifter bore diameter is not within specification, ream cylinder block bore for next oversize valve lifter. Refer to VALVE LIFTERS  table under ENGINE SPECIFICATIONS.
NOTE: Cylinder block is marked to indicate oversize valve lifters. See SPECIAL ENGINE MARKS under IDENTIFICATION .
scientia non olet · About LEMON Manuals