LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Engine Controls - Tests W/Codes - 1.8L) >> Self-Diagnostic System >> Entering On-Board Diagnostics (Using DRB)

Entering On-Board Diagnostics (Using DRB)

WARNING: This page is about a different car, the 1994 Plymouth Laser and 1994 Eagle Talon. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before entering on-board diagnostics, refer to PRETEST INSPECTION . Turn ignition off. Attach Mitsubishi Motors Corporation (MMC) cartridge to DRB. Connect DRB to diagnostic connector. Diagnostic connector is located next to junction block, above left kick panel. See Figure.
  2. Ensure all accessories are off. Turn ignition on. All character positions will illuminate and copyright information will appear on screen for a few seconds. Display will then change to DRB menu. If DRB displays an error message, refer to DRB ERROR SCREENS.
scientia non olet · About LEMON Manuals