Test Dr-18A - Testing Purge System
WARNING: This page is about a different car, the 1994 Plymouth Laser and 1994 Eagle Talon. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION . For appropriate wiring diagram, see WIRING DIAGRAMS .
- Connect DRB and adapter to diagnostic connector. Using DRB, actuate purge control solenoid. Listen for purge control solenoid to click. If purge control solenoid clicks, inspect purge control vacuum system. Repair as necessary. Perform TEST VER-2 . If purge control vacuum system is okay, perform TEST DR-19A.
- If purge control solenoid does not click, disconnect purge control solenoid connector. Measure voltage at purge control solenoid connector terminal No. 2 (Yellow/White wire). If voltage is less than 10 volts, repair open Yellow/White wire between purge control solenoid and splice. Perform TEST VER-2. If voltage is more than 10 volts, turn ignition switch to OFF position.
- Disconnect Electronic Control Unit (ECU) 18-pin connector. Measure resistance of Black/White wire between ECU 18-pin connector terminal No. 62 and purge control solenoid connector terminal No. 1. If resistance is more than 10 ohms, repair open Black/White wire. Perform TEST VER-2.
- If resistance is less than 10 ohms, measure resistance between purge control solenoid connector terminal No. 1 (Black/White wire) and ground. If resistance is more than 10 ohms, replace purge control solenoid. Perform TEST VER-2. If resistance is less than 10 ohms, repair Black/White wire for a short to ground. Perform TEST VER-2.