Test 8E - Short To 5 Volts
WARNING: This page is about a different car, the 1995 Dodge Ram Wagon, 1995 Dodge Ram Van, 1995 Dodge Pickup, and 1995 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION in appropriate TESTS W/CODES
article below. For appropriate wiring diagram, see WIRING DIAGRAMS
section. Perform TEST VER-1 after each repair.
CAUTION:
Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.
Using scan tool in ohmmeter mode, check resistance at instrument cluster connector, ground circuit (Black/Light Green wire). If resistance is more than 5 ohms, repair open Black/Light Green wire. Perform TEST VER-1. If resistance is less than 5 ohms, replace MIC or EIC. Perform TEST VER-1.