LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Cherokee Classic, Part Time, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 71 (CRUISE CONTROL SYSTEMS - 95 Cirrus & Stratus (VIN X), 96 Breeze, Cirrus & Stratus) >> Testing >> Vacuum Supply

Vacuum Supply

WARNING: This page is about a different car, the 1996 Plymouth Breeze, 1996 Dodge Stratus, 1996 Chrysler Cirrus, 1995 Dodge Stratus, and 1995 Chrysler Cirrus. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect vacuum hose at speed control servo. Install vacuum gauge to disconnected vacuum hose. Start engine and observe gauge. Vacuum reading should be a minimum of 10 in. Hg. Turn engine off. Vacuum should continue to hold at a minimum of 10 in. Hg.
  2. If vacuum is not as specified, check for kinked or leaking vacuum lines, defective check valve, defective vacuum reservoir and/or poor engine performance. If no problems are found, check speed control servo. See SPEED CONTROL SERVO .
scientia non olet · About LEMON Manuals