LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Cherokee Classic, Part Time, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 71 (CRUISE CONTROL SYSTEMS - 95 Cirrus & Stratus (VIN X), 96 Breeze, Cirrus & Stratus) >> Self-Diagnostics Tests >> Test SC-3A - Checking Speed Control Set/Resume Switch

Test SC-3A - Checking Speed Control Set/Resume Switch

WARNING: This page is about a different car, the 1996 Plymouth Breeze, 1996 Dodge Stratus, 1996 Chrysler Cirrus, 1995 Dodge Stratus, and 1995 Chrysler Cirrus. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Perform TEST SC-1A - CHECKING SPEED CONTROL OPERATION  before proceeding.
  1. Disconnect 2-pin SET/RESUME switch connector (located behind speed control SET/RESUME switch). Connect a jumper wire between 2-pin speed control SET/RESUME switch connector terminals.
  2. Turn ignition on. Using scan tool, read speed control switch voltage. If voltage is one volt or more, repair open speed control switch signal circuit Red/Light Green wire. Perform TEST SC-VER - SPEED CONTROL VERIFICATION . If voltage is less than one volt, replace speed control SET/RESUME switch. Perform TEST SC-VER - SPEED CONTROL VERIFICATION .
scientia non olet · About LEMON Manuals