LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Cherokee Classic, Part Time, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 71 (CRUISE CONTROL SYSTEMS - 95 Cirrus & Stratus (VIN X), 96 Breeze, Cirrus & Stratus) >> Self-Diagnostic System >> Retrieving Diagnostic Trouble Codes >> Using Scan Tool

Using Scan Tool

WARNING: This page is about a different car, the 1996 Plymouth Breeze, 1996 Dodge Stratus, 1996 Chrysler Cirrus, 1995 Dodge Stratus, and 1995 Chrysler Cirrus. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure battery is fully charged. Attempt to start engine. Turn ignition off. Connect scan tool to Data Link Connector (DLC), located below driver's side of instrument panel.
  2. Turn ignition on. Using scan tool manufacturer's instructions, record all DTCs displayed on scan tool. Using all DTCs obtained, proceed to appropriate TESTS W/CODES article in ENGINE PERFORMANCE. Once all repairs are made, ensure DTCs are cleared from PCM. See CLEARING DIAGNOSTIC TROUBLE CODES .
scientia non olet · About LEMON Manuals