LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1995 >> Cherokee Country, RWD, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Parking Brake Lever (XL With Full Console) >> Removal

Parking Brake Lever (XL With Full Console): Removal

  1. Release parking brakes.
  2. Raise vehicle.
  3. Remove adjusting nut from tensioner rod. Then temporarily secure equalizer to nearby chassis component with wire.
  4. Remove nuts attaching lever support plate to underside of floorpan.
  5. Lower vehicle.
  6. On models with manual transmission, remove shift knob, outer boot, and bezel,
  7. On models with automatic transmission remove shift handle cap and remove plunger, spring and T-lock.
  8. Remove shift handle by pulling upward sharply on handle. Then remove shift bezel.
  9. Remove console cover screws.
  10. On models with power mirror switch, pry switch out of console cover and disconnect switch connector.
  11. Remove cover from console to brackets and shifter covers.
  12. Remove console.
  13. Remove duct.
  14. Disconnect wire at parking brake switch on lever.
  15. Remove lever and cable tensioner assembly from floorpan.
  16. Move cover and boot aside for access to lever arm.
  17. Remove E-clip and pin that connect tensioner to lever arm.
  18. Parking brake switch can be replaced at this time if necessary.
scientia non olet · About LEMON Manuals