LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1995 >> Cherokee Country, RWD, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Parking Brake Lever (XL With Full Console) >> Installation

Parking Brake Lever (XL With Full Console): Installation

  1. Assemble lever and tensioner. Be sure E-clip is fully engaged in retaining pin.
  2. Verify that tensioner boot is fully seated in cover.
  3. Position assembled lever and tensioner in floor pan.
  4. Install parking brake switch on lever if removed, and connect brake warning light wires to switch.
  5. Install duct and console.
  6. Connect power mirror switch wire to switch and install switch in console cover.
  7. Install console cover.
  8. On automatic transmission models, install shift bezel and shift handle.
  9. On manual transmission models, install bezel outer boot, and shift knob.
  10. Raise vehicle.
  11. Insert tensioner rod in equalizer and install adjusting nut on tensioner rod.
  12. Install nuts attaching lever support plate to floorpan and lever.
  13. Adjust parking brakes. See PARKING/EMERGENCY BRAKE  .
  14. Lower vehicle and verify proper parking brake operation.
scientia non olet · About LEMON Manuals