LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1995 >> Cherokee Country, RWD, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Overhaul >> Master Cylinder >> Two-Piece Master Cylinder Reservoir Replacement

Two-Piece Master Cylinder Reservoir Replacement

  1. Remove reservoir cap and empty brake fluid. Using a pin punch and hammer, remove roll pins. Place master cylinder in a soft jawed vice.
  2. Loosen reservoir from grommets with a pry tool. Rock reservoir side-to-side while pulling up and remove from grommets. Remove grommets from master cylinder body. Lubricate new grommets with clean brake fluid. Using only finger pressure, install and seat grommets.
  3. Start reservoir in grommets. Rock reservoir side-to-side while pressing downward to seat reservoir into grommets. Install roll pins. Fill reservoir and bench bleed master cylinder. See MASTER CYLINDER BLEEDING under BLEEDING BRAKE SYSTEM  .
scientia non olet · About LEMON Manuals