LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1995 >> Cherokee Country, RWD, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Bleeding Brake System >> Pressure Bleeding

Pressure Bleeding

  1. Bleeding can be performed using pressure or vacuum equipment. Both methods are effective and should be used according to manufacturers instructions.
  2. Clean master cylinder cap and surrounding area. Remove cap. With pressure tank at least 1/2 full, connect to master cylinder with adapters. Attach bleed hose to first bleeder valve to be serviced. See BRAKELINE BLEEDING SEQUENCE  table under BLEEDING SEQUENCE. Place other end of hose in clean glass jar partially filled with clean brake fluid so end of hose is submerged in fluid.
  3. Open release valve on pressure bleeder. Follow equipment manufacturer's pressure instructions. Open the bleeder valve at wheel 3/4 turn, and note fluid flow. Close bleeder screw when fluid is free of bubbles. Repeat procedure on remaining wheels in proper sequence. Check brake pedal operation after bleeding has been completed. Remove pressure bleeding equipment and valve retainer from hold-off valve. Ensure master cylinder is full of fluid. Check for leaks.
scientia non olet · About LEMON Manuals