LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1995 >> Cherokee Country, RWD, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Bleeding Brake System >> Manual Bleeding >> Vehicles Not Equipped With ABS Brakes

Vehicles Not Equipped With ABS Brakes

  1. Fill master cylinder with clean brake fluid that meets DOT 3 specifications. Open all wheel bleed valves and allow system to gravity bleed. Close bleeder valves when fluid begins flowing from each valve. Refill master cylinder.
  2. Bleed master cylinder and combination valve at brakeline fittings. Depress brake pedal slowly through full travel. Close brakeline fitting, and release pedal. When air is removed, tighten brakelines to specification. See TORQUE SPECIFICATIONS  .
  3. Install bleed hose to first bleeder valve to be serviced. See BRAKELINE BLEEDING SEQUENCE  table under BLEEDING SEQUENCE. Submerge other end of hose in clean glass jar partially filled with clean brake fluid. See Fig 1 .
  4. Open bleeder valve 1/2 to 3/4 turn. Depress brake pedal slowly through full travel. Close bleeder valve, and release pedal. Repeat procedure until flow of fluid shows no signs of air bubbles. Refill master cylinder reservoir and ensure proper system operation.
Fig 1: Bleeding Brakes (Manual Procedure)
G95I26896Courtesy of CHRYSLER CORP.
scientia non olet · About LEMON Manuals