LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1992 >> Cherokee Limited >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Drive Axle - 7.125", 7.56" (7 9/16"), 8.25" & 8.5" >> Removal & Installation >> Rear Axle Shaft, Bearing, Seals & Retainer >> Installation

Rear Axle Shaft, Bearing, Seals & Retainer: Installation

  1. Grease bearing and install in axle tube. Apply wheel bearing grease to axle shaft seal. Install seal in axle tube. Install axle shaft.
  2. Install axle "C" clip. Pull axle out to seat "C" clip. Install pinion shaft. Install lock screw and tighten to specification. Install pinion shaft spring clips (if equipped). Apply RTV to axle housing cover. Tighten the cover bolts to proper specification. See TORQUE SPECIFICATIONS  table. Fill with gear oil.
    NOTE: On vehicles with Trac-Lok (limited slip) differentials, slowly drive vehicle in 10-12 "figure 8" patterns to distribute lubricant to clutch and bearing assembly.
scientia non olet · About LEMON Manuals