LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1990 >> Wagoneer >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Drive Axle - 7.56" (7 9/16"), 8.25", & 8.5" >> Adjustments >> Carrier Bearing Preload Adjustments >> Grand Wagoneer

Grand Wagoneer

  1. Remove carrier bearing from side opposite ring gear. Preload carrier bearings by adding .015" (.38 mm) to carrier bearing mount (between ring gear and carrier). Install carrier bearing. Mount Housing Spreader (J-24385-01) on axle housing. Mount Dial Indicator (J-8001). Spread housing enough to remove differential. See Figure .
    CAUTION: DO NOT  spread housing more than .015" (.38 mm), or damage to housing may result.
  2. Position carrier assembly into axle housing bearing bores. Tap bearing cups until fully seated in housing. Remove housing spreader. Install bearing caps, aligning marks made at disassembly. Install and tighten bolts. Recheck ring gear backlash.
scientia non olet · About LEMON Manuals