LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1990 >> Cherokee Laredo, 2D Utility, Automatic >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 4.0L 6-CYL - VIN [L] & 4.2L 6-CYL - VIN [T] >> Removal & Installation >> Front Cover Oil Seal

Front Cover Oil Seal

  1. Remove vibration damper. Pry seal from front cover. Use care not to damage seal area. Position new seal on Front Cover Seal Installer (6139) with lip facing outward.
  2. Apply sealant to seal outer diameter. Lightly coat crankshaft with oil. Place front cover seal installer on front of crankshaft. Tap seal into front cover. Lightly coat seal contact area of vibration damper with oil.
  3. Install key in crankshaft (if removed). Install vibration damper. Lubricate vibration damper bolt with oil. Install retaining bolt and washer. Torque to specification. See TORQUE SPECIFICATIONS table at end of this article.
scientia non olet · About LEMON Manuals