LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1988 >> Wagoneer >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 4.0L 6-CYL - VIN [M] & 4.2L 6-CYL - VIN [C] >> Removal & Installation >> Rod Bearing >> Installation

Rod Bearing: Installation

  1. Note color code on edge of bearings removed. Install bearings. Using Plastigage method, check bearing clearances. Replace bearings as necessary to obtain correct clearance. Bearings are available in standard and undersize application.
  2. If required, different sized upper and lower bearings may be installed to obtain correct oil clearance. Tighten bolts to specification. Check rod side play. Rotate crankshaft to ensure freedom of movement. Reverse removal procedure for remaining components. Tighten bolts to specification.
NOTE: Avoid combining bearing inserts in excess of .001" (.02 mm) difference in size.
scientia non olet · About LEMON Manuals