LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1988 >> Comanche Eliminator, Automatic >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 4.0L 6-CYL - VIN [M] & 4.2L 6-CYL - VIN [C] >> Lubrication >> Oil Pump >> Reassembly & Installation

Reassembly & Installation

  1. Reverse procedures for reassembly and installation. Apply Permatex No. 2 to pick-up pipe prior to installation. Using Pipe Installer (J-21882), install pick-up pipe. Ensure pick-up pipe support bracket is aligned with pump cover bolt.
  2. Fill gear cavity with petroleum jelly prior to installing cover. Apply Loctite on pump cover area. Install cover and bolts. Tighten bolts to specification. Check pump gears for freedom of rotation.
  3. Install oil pump and new gasket. Tighten retaining bolts to specification.
Fig 1: Exploded View of Oil Pump Assembly
G91246Courtesy of CHRYSLER MOTORS.
scientia non olet · About LEMON Manuals