LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1988 >> Comanche Eliminator, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Disc Brake Rotor - Grand WAGONEER >> Installation

Disc Brake Rotor - Grand WAGONEER: Installation

  1. Lubricate bearings with "EP" type waterproof wheel bearing grease. Install bearings and seal in rotor. Install rotor and inner lock nut. Inner lock nut has a locating peg on one side. When installed, peg must face away from bearing.
  2. Install wheel, but do not tighten lug nuts completely. Tighten inner lock nut to 50 ft. lbs. (68 N.m) while rotating wheel. Back of inner lock nut 1/6 turn (45-65 degrees).
  3. Install retaining washer. Ensure that inner lock nut locating peg is engaged with retaining washer. Install outer lock nut and tighten to 50 ft. lbs. (68 N.m).
  4. On models without front hubs, install pressure spring cup, pressure spring, drive gear and snap ring. Coat rim of chrome hub cover with Permatex No. 3 and install cap in rotor hub.
    NOTE: Recessed side of spring cup faces outer bearing and flat side faces pressure spring.
  5. On models with front hubs, install hub clutch on axle. Install large and small hub retaining rings. Install hub body on clutch and tighten to 30 INCH lbs. (3 N.m). Reverse removal procedure to complete installation.
scientia non olet · About LEMON Manuals