Disc Brake Rotor - CHEROKEE, COMANCHE & WAGONEER: Installation

Apply small amount of "EP" type waterproof wheel bearing grease in hub cavity. Lubricate inner and outer bearings. Install inner bearing and seal in rotor. Clean rotor surface (if necessary).
Install hub and rotor on spindle. Install outer bearing, thrust washer and spindle nut. Tighten spindle nut to 17-25 ft. lbs. (23-34 N.m) while rotating rotor to seat bearings. Loosen spindle nut 1/2 a turn and retighten an additional 19 INCH lbs (2 N.m). Reverse removal procedure to complete installation.