Disc Brake Pads: Removal
- Drain 2/3 of brake fluid from master cylinder reservoir. Raise vehicle and support with safety stands. Remove front wheel assembly.
- Place "C" clamp on caliper. Solid end of clamp should contact back of caliper. Screw end should contact metal part of outboard shoes.
- Tighten "C" clamp until caliper forces piston to bottom of bore. Remove both Allen head mounting bolts and lift caliper off rotor. Support caliper out of the way.
- On Grand Wagoneer, remove both brake pads from caliper. Note spring position and support spring from inboard shoe. Remove sleeves and bushings from caliper.
- On all other models, hold anti-rattle clip against caliper adapter and remove outer brake pad. Remove inner brake pad and anti-rattle clip from caliper adapter.