LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1988 >> Comanche Eliminator, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Brake System Bleeding >> Master Cylinder Bleeding >> Bleeding On Vehicle

Bleeding On Vehicle

  1. Install master cylinder on vehicle after bench bleeding. Remove bleeder lines and install brake lines. DO NOT  fully tighten brake lines at this time.
  2. Slowly force brake pedal to the floor and hold in this position. Tighten brake lines and release brake pedal. Repeat procedure until no air bubbles exist at brake lines. Remaining wheel cylinder or calipers may be require bleeding.
scientia non olet · About LEMON Manuals