Section 43 (Removal & Installation - A/T): Installation
WARNING: This page is about a different car, the 1988 Jeep Wrangler, 1988 Jeep Wagoneer, 1988 Jeep Grand Wagoneer, 1988 Jeep Comanche, and 1988 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
To install, reverse removal procedures. DO NOT tighten exhaust pipe attaching bolts until crossmember has been installed and transmission jack has been removed. Make sure all index marks made at removal are aligned. Tighten all bolts to specification and fill transmission and transfer case with fluid.