Jeep V8 Models
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1983 Jeep Wagoneer, 1983 Jeep Scrambler, 1983 Jeep Pickup, 1983 Jeep Cherokee, and 1983 Jeep CJ7. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect throttle control rod spring. Use spring to hold transmission throttle valve control lever against forward stop. Block choke open and release fast idle cam.
All Jeep models equipped with V8 engines.
- On carburetors equipped with throttle operated solenoid valve, turn key to 'ON' position to energize solenoid. Open throttle halfway to allow solenoid to lock. Return throttle to idle position.
- Loosen retaining bolt on throttle control rod adjusting link. Remove spring clip and slide nylon washer to rear of link. Push on end of link to eliminate lash and tighten retaining bolt. Install nylon washer and spring clip. Reconnect throttle control rod spring.