Jeep 6-Cylinder Models with 727 Transmission

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1983 Jeep Wagoneer, 1983 Jeep Scrambler, 1983 Jeep Pickup, 1983 Jeep Cherokee, and 1983 Jeep CJ7. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect throttle control rod spring. Use spring to hold transmission throttle control lever forward, against stop. Block choke open and release fast idle cam.
On carburetors equipped with throttle operated solenoid valve, turn key to 'ON' position to energize solenoid. Open throttle halfway to allow solenoid to lock. Return throttle to idle position.
Loosen retaining bolt on throttle control adjusting link. DO NOT remove spring clip or nylon washer. Pull on end of link to eliminate lash. Tighten link retaining bolt. Reconnect throttle control rod spring.

Fig 1: Throttle Rod Adjustment

All Jeep 6-Cylinder models with 727 transmission.