Low-Reverse (Rear) Band
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1983 Jeep Wagoneer, 1983 Jeep Scrambler, 1983 Jeep Pickup, 1983 Jeep Cherokee, and 1983 Jeep CJ7. However, it is still accessible from the selected car via links, so may be relevant.
- Raise vehicle, drain transmission fluid and remove oil pan Locate adjusting screw on rear servo lever. Loosen adjusting screw lock nut and back off about 5 turns.
- Tighten screw to correct torque and back off indicated number of turns. See LOW-REVERSE (REAR) BAND ADJUSTMENT . Hold adjusting screw in position and tighten lock nut to 235 ft. lbs. (48 N.m.). Install oil pan and fill transmission with fluid.
LOW-REVERSE (REAR) BAND ADJUSTMENT
| Engine/Application | Tighten Screw to INCH lbs. (N.m) | Back Off Screw |
|---|---|---|
| Model 727 | 41 (4.6) | 2 Turns |
| Model 999 | 41 (4.6) | 4 Turns |