Low-Reverse Servo & Band (Rear)

Install servo piston into case with twisting motion. Place spring, retainer and snap ring over piston. Install snap ring.
On models with double-wrapped band, install replacement "O" ring on reaction pin. Insert pin into case so both lugs rest against reaction pin. Install low-reverse drum into rear band. Screw in band adjuster enough to hold strut in place. Install operating lever and pivot pin.
On all other models, position rear band in case. Install short strut. Connect long link and anchor to band. Screw in band adjuster enough to hold strut in place. Install low-reverse drum.

Fig 1: Double-Wrapped Low-Reverse Band & Linkage

Courtesy of CHRYSLER MOTORS

Fig 2: Double-Wrapped Band Linkage Installation

Courtesy of CHRYSLER MOTORS

Fig 3: Low-Reverse Band & Linkage (727 Model)

Courtesy of CHRYSLER MOTORS