LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1983 >> Scrambler Base, 4.2 C, Standard, T4 >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Diagnosis & Overhaul - 727, 904, 998 & 999 >> Component Disassembly & Reassembly >> Valve Body Reassembly >> Shuttle Valve & Governor Plugs

Shuttle Valve & Governor Plugs

  1. Place 1-2 and 2-3 shift valve governor plugs and shuttle valve in bores. Install spring guides, secondary spring and "E" clip on opposite end of valve.
  2. Install primary shuttle valve spring and throttle plug into bore. Install governor end plate. Tighten retaining screws. Install shuttle valve cover plate. Tighten retaining screws.
Fig 1: Exploded View of Pressure Regulators & Manual Controls
G96F15664Courtesy of CHRYSLER MOTORS
scientia non olet · About LEMON Manuals