LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1983 >> Scrambler Base, 4.2 C, Standard, T4 >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Diagnosis & Overhaul - 727, 904, 998 & 999 >> Component Disassembly & Reassembly >> Rear Clutch >> Disassembly

Rear Clutch: Disassembly

  1. Remove pressure plate snap ring from clutch retainer. Lift pressure plate, clutch plates and inner pressure plate from retainer. Prying from one end of wave spring, remove wave spring, spacer ring (727 model) and clutch piston spring from clutch retainer.
  2. Invert clutch piston retainer assembly. Tapping on wooden block, remove piston. Remove seals from piston. Remove snap ring and input shaft (if necessary).
scientia non olet · About LEMON Manuals