LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1983 >> Scrambler Base, 4.2 C, Standard, T4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Servicing - A/T) >> Adjustments >> Transmission Throttle Rod

Transmission Throttle Rod

WARNING: This page is about a different car, the 1984 Plymouth Gran Fury, 1984 Dodge Diplomat, and 1984 Chrysler Fifth Avenue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Make sure carburetor is not on fast idle cam (disconnect choke if necessary). Raise vehicle on hoist to make adjustment at transmission throttle lever. Loosen adjustment swivel lock screw.
    NOTE: Swivel must be free to slide along flat end of throttle rod so that preload spring action is not restricted.
  2. Hold transmission lever firmly forward against its internal stop and tighten swivel lock screw. This completes throttle rod adjustment, as linkage backlash was automatically removed by the preload spring.
  3. To check linkage freedom of operation, move throttle rod rearward, and release slowly. Ensure it returns to full forward position.
    Fig 1: Throttle Rod Adjustment Diagram on RWD V8 Models
    G35236

    Swivel must be free to slide on throttle rod for proper adjustment.

scientia non olet · About LEMON Manuals