LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1983 >> Scrambler Base, 4.2 C, Standard, T4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 47 (Removal & Installation - A/T) >> Automatic Transmission >> Removal

Automatic Transmission: Removal

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 1990 Jeep Wrangler, 1990 Jeep Wagoneer, 1990 Jeep Grand Wagoneer, 1990 Jeep Comanche, and 1990 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect fan shroud and transmission fill tube upper bracket. Raise and support vehicle. Remove converter inspection cover and fill tube. Remove starter.
  2. Mark drive shafts for reassembly. Disconnect drive shafts at transfer case. On V8 models, disconnect exhaust pipes from exhaust manifolds. Drain transfer case lubricant. Disconnect speedometer cable from transmission.
  3. Disconnect all shift and throttle linkages and wiring from transmission and transfer case. Mark torque converter drive plate and torque converter for reassembly reference. Remove torque converter-to-drive plate bolts.
  4. Support transmission/transfer case assembly with jack and secure with chain. Remove rear transmission crossmember. Lower transmission enough to disconnect cooler lines at transmission. Remove transmission-to-engine retaining bolts. Remove transmission and transfer case. Hold torque converter in position while removing transmission assembly.
scientia non olet · About LEMON Manuals