LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1983 >> Scrambler Base, 4.2 C, Standard, T4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Removal & Installation - A/T) >> Removal & Installation - Transfer Case >> Model NP-208 >> Removal

Model NP-208: Removal

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1987 Jeep Wrangler, 1987 Jeep Wagoneer, 1987 Jeep Pickup, 1987 Jeep Grand Wagoneer, and 1987 Jeep Comanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise vehicle. Drain lubricant from transfer case. Disconnect speedometer cable and indicator switch wires and disconnect transfer case shift lever link at operating lever. Place a safety stand under transmission and remove the rear transmission crossmember.
  2. Mark transfer case front and rear output shaft yokes and drive shafts for assembly alignment reference. Disconnect front and rear drive shafts at transfer case yokes. Secure shafts to frame rails with wire. Disconnect parking brake cable guide from pivot located on right frame rail, if necessary.
  3. Remove bolts attaching exhaust pipe support bracket-to-transfer case (if necessary). Remove transfer case-to-transmission bolts. Move transfer case assembly rearward until free of transmission output shaft and remove assembly. Remove all gasket material from rear of transmission adapter housing.
scientia non olet · About LEMON Manuals