LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1983 >> Scrambler Base, 4.2 C, Standard, T4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 43 (Removal & Installation - A/T) >> Removal & Installation - Transfer Case >> Model NPE-300 >> Removal

Model NPE-300: Removal

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1985 Jeep Wagoneer, 1985 Jeep Scrambler, 1985 Jeep Pickup, 1985 Jeep Grand Wagoneer, and 1985 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove floor covering, if equipped and remove transmission access cover from floorpan. Raise vehicle and drain lubricant from transfer case. Position support stand under clutch housing to support engine and transmission and remove rear crossmember.
  2. Disconnect front and rear drive shafts at transfer case. Mark drive shaft yokes for assembly reference. Disconnect speedometer cable at transfer case. If necessary, disconnect parking brake cable at equalizer. Disconnect exhaust pipe support bracket at transfer case, if equipped. Remove bolts attaching transfer case to transmission and remove transfer case.
scientia non olet · About LEMON Manuals