LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1983 >> Scrambler Base, 4.2 C, Standard, T4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 43 (Removal & Installation - A/T) >> Removal & Installation - Transfer Case >> Model NP-229 >> Removal

Model NP-229: Removal

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1985 Jeep Wagoneer, 1985 Jeep Scrambler, 1985 Jeep Pickup, 1985 Jeep Grand Wagoneer, and 1985 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support vehicle. Drain lubricant from transfer case. Disconnect speedometer cable and vent hose. Disconnect transfer case shift lever link at operating lever. Place a safety stand under transmission and remove rear crossmember.
  2. Mark transfer case front and rear output shafts at transfer case yokes and drive shafts for installation alignment reference. Disconnect front and rear drive shafts at transfer case yokes. Secure Shafts. Disconnect shift motor vacuum hoses.
  3. Disconnect transfer case shift linkage. Remove transfer case-to-transmission bolts. Move transfer case assembly rearward until clear of transmission output shaft and remove assembly. Remove all gasket material from rear of transmission adapter housing.
scientia non olet · About LEMON Manuals