LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1983 >> Scrambler Base, 4.2 C, Standard, T4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (Removal & Installation - A/T) >> Removal & Installation - Transfer Case >> Model NP-207 >> Removal

Model NP-207: Removal

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1984 Jeep Wagoneer, 1984 Jeep Scrambler, 1984 Jeep Pickup, 1984 Jeep Grand Wagoneer, and 1984 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Shift transfer case into "4H" position. Raise and support vehicle. Drain lubricant from transfer case. Mark rear axle yoke and drive shaft for installation reference. Remove rear drive shaft. Disconnect speedometer cable, vacuum hoses and vent hose from transfer case.
  2. Raise transmission and transfer case and remove transmission crossmember attaching bolts. Remove crossmember and lower transmission and transfer case. Mark transfer case front output shaft flange and drive shaft for installation reference.
  3. Disconnect front drive shaft from transfer case. Disconnect shift lever linkage rod at transfer case. Remove shift lever bracket bolts. Support transfer case and remove transfer case attaching bolts. Remove transfer case assembly.
scientia non olet · About LEMON Manuals