Removal & Installation: Transmission: Installation
WARNING: This page is about a different car, the 1990 Dodge Ram Wagon, 1990 Dodge Ram Van, 1990 Dodge Pickup, 1990 Dodge Dakota, and 1990 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Coat converter hub hole in crankshaft with multipurpose grease. Place transmission assembly on jack and position under vehicle. Make sure marks on converter and drive plate (made during removal) are aligned.
- Carefully work transmission assembly into position over dowels. Install all converter housing-to-engine retaining bolts. Tighten bolts to specification.
- To complete installation, reverse removal procedure. Adjust shift and throttle linkages and fill transmission with fluid. Use Mopar ATF Plus Type 7176 or Dexron II automatic transmission fluid. On 4WD models, install transfer case.