LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1983 >> Scrambler Base, 4.2 C, Standard, T4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (Removal & Installation - A/T) >> Removal & Installation >> Transfer Case - Model NP-205 >> Removal

Transfer Case - Model NP-205: Removal

WARNING: This page is about a different car, the 1990 Dodge Ram Wagon, 1990 Dodge Ram Van, 1990 Dodge Pickup, 1990 Dodge Dakota, and 1990 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support vehicle. Drain transfer case. Disconnect speedometer cable. Mark front and rear drive shaft yokes for installation reference.
    CAUTION: DO NOT  allow drive shaft to hang free, as damage to universal joints may result.
  2. Disconnect drive shaft at transfer case. Move shaft aside for working clearance and secure to frame rails with wire. Disconnect shift lever rod from shift rail link.
  3. Support transfer case with transmission jack. Remove bolts and nuts attaching transfer case-to-transmission adapter. Move transfer case to rear until input shaft clears adapter. Lower transfer case from vehicle.
scientia non olet · About LEMON Manuals