LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1983 >> Scrambler Base, 4.2 C, Standard, T4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Removal & Installation - A/T) >> Transfer Case >> Model NP-205 >> Removal

Model NP-205: Removal

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1989 Dodge Ramcharger, 1989 Dodge Ram Wagon, 1989 Dodge Ram Van, 1989 Dodge Pickup, and 1989 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise vehicle and drain transfer case. Replace plug. Disconnect speedometer cable. Remove skid plate, crossmember and strut rods as needed. Disconnect drive shafts and wire out of way. DO NOT allow drive shafts to hang free, as damage to universal joints may result.
  2. Disconnect shift lever rod from shift rail link. Support transfer case and remove transfer case-to-transmission adapter bolts. Move transfer case to rear until input shaft clears adapter. Lower transfer case from vehicle.
scientia non olet · About LEMON Manuals