LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1983 >> Scrambler Base, 4.2 C, Standard, T4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Removal & Installation - A/T) >> Transfer Case >> Model NP-208 >> Removal >> Notes

Model NP-208: Removal: Notes

WARNING: This page is about a different car, the 1984 Dodge Ramcharger, 1984 Dodge Ram Wagon, 1984 Dodge Ram Van, 1984 Dodge Pickup, and 1984 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise vehicle, remove plug and drain transfer case. Mark front and rear output shaft yokes and drive shafts for reassembly reference. Disconnect speedometer cable and indicator switch wires.
  2. Disconnect shift lever link from operating lever. Support transfer case with transmission jack and remove crossmember. Disconnect front and rear drive shafts at yokes and wire to frame.
  3. If necessary, disconnect parking brake cable guide from pivot on right frame rail. Remove bolts attaching exhaust pipe support bracket to transfer case. Remove transfer case-to-transmission bolts.
  4. Move assembly to the rear until clear of output shaft. Lower transfer case from vehicle. Remove all gasket material from rear of the transmission adapter housing.
scientia non olet · About LEMON Manuals