LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1983 >> Scrambler Base, 4.2 C, Standard, T4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 34 (Removal & Installation - A/T) >> Removal & Installation - Transfer Case >> Model NP-208 >> Removal

Model NP-208: Removal

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1983 Plymouth Voyager, 1983 Dodge Ramcharger, 1983 Dodge Ram Wagon, 1983 Dodge Ram Van, and 1983 Dodge Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise vehicle, remove plug and drain transfer case. Mark front and rear output shaft yokes and drive shafts for reassembly reference. Disconnect speedometer cable and indicator switch wires. Disconnect shift lever link from operating lever.
  2. Support transfer case with transmission jack and remove crossmember. Disconnect front and rear drive shafts at yokes and wire to frame.
  3. If necessary, disconnect parking brake cable guide from pivot on right frame rail. Remove bolts attaching exhaust pipe support bracket to transfer case. Remove transfer case-to-transmission bolts. Move assembly to the rear until clear of output shaft. Lower transfer case from vehicle.
  4. Remove all gasket material from rear of transmission adapter housing.
scientia non olet · About LEMON Manuals