LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1983 >> Scrambler Base, 4.2 C, Standard, T4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Servicing - A/T) >> Adjustments >> Transmission Throttle Linkage Adjustment >> V8 Engines

V8 Engines

WARNING: This page is about a different car, the 1990 Jeep Wrangler, 1990 Jeep Wagoneer, 1990 Jeep Grand Wagoneer, 1990 Jeep Comanche, and 1990 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect throttle control rod spring at carburetor. Block choke open and release fast idle cam.
  2. On carburetor equipped with throttle operated solenoid valve, turn ignition on to energize solenoid. Open throttle halfway to allow solenoid to lock. Return throttle to idle position.
  3. Loosen retaining bolt on throttle rod. Remove spring clip from nylon stop. Remove nylon stop and reposition at rear of link. See Fig 1. Hold bellcrank in place. Push on end of link to eliminate lash. Tighten retaining bolts. Install nylon stop and spring clip. Connect throttle rod spring.
    Fig 1: Adjusting Throttle Linkage on V8 Models
    G121181Courtesy of CHRYSLER LLC
scientia non olet · About LEMON Manuals