LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1983 >> Scrambler Base, 4.2 C, Standard, T4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Servicing - A/T) >> Adjustments >> Transmission Throttle Linkage Adjustment >> 4-Cylinder Engine

4-Cylinder Engine

WARNING: This page is about a different car, the 1990 Jeep Wrangler, 1990 Jeep Wagoneer, 1990 Jeep Grand Wagoneer, 1990 Jeep Comanche, and 1990 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Shift transmission into Park position. Raise vehicle. Release cable adjuster clamp to unlock cable. Unsnap cable from bracket. Move transmission shift lever all the way rearward into Park detent on left side of case. Verify position by trying to turn drive shaft. Shaft will not turn in Park position.
  2. Snap cable into cable bracket. Push cable adjuster clamp down until it snaps into place. To check for proper adjustment, engine should only start in Park and Neutral. See Fig 1.
    Fig 1: Adjusting Shift Cable
    G90B04353Courtesy of CHRYSLER LLC
scientia non olet · About LEMON Manuals