LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1983 >> Scrambler Base, 4.2 C, Standard, T4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Servicing - A/T) >> Adjustments >> Shift Linkage Adjustment >> Cable Linkage >> Notes

Cable Linkage: Notes

WARNING: This page is about a different car, the 1990 Jeep Wrangler, 1990 Jeep Wagoneer, 1990 Jeep Grand Wagoneer, 1990 Jeep Comanche, and 1990 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place gearshift lever in Park and raise vehicle. Using a small screwdriver, unlock shift control cable by releasing "U" shaped cable adjuster clamp. Remove cable from mounting bracket.
  2. Move transmission shift lever rearward until fully seated in Park detent. Ensure that drive shaft cannot be rotated. Snap control cable into cable mounting bracket and replace "U" shaped cable adjuster clamp.
  3. Lower vehicle and verify engine starting. Engine should start only with shifter in Park or Neutral.
scientia non olet · About LEMON Manuals