LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1983 >> Scrambler Base, 4.2 C, Standard, T4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Servicing - A/T) >> Lubrication >> Draining & Refilling >> Transmission >> Notes

Draining & Refilling: Transmission: Notes

WARNING: This page is about a different car, the 1989 Jeep Wrangler, 1989 Jeep Wagoneer, 1989 Jeep Grand Wagoneer, 1989 Jeep Comanche, and 1989 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Loosen oil pan bolts, tap pan to break it loose and allow fluid to drain. Remove pan and oil filter. Install new filter on bottom of valve body and tighten retaining screws to 35 INCH lbs. (4 N.m). Clean oil pan and install with new gasket, Tighten bolts to 150 INCH lbs. (17 N.m).
  2. Refill transmission with approximately 5 qts. (4.7L) of Mercon ATF. Start engine and allow to run at curb idle. With vehicle on level surface, engine idling and parking brake applied, move shift selector lever through all gear ranges, ending in Neutral (Park for Aisin Warner AW-4 transmission).
  3. Recheck fluid level when transmission reaches normal operating temperature. Add fluid to reach "FULL" mark on dipstick.