LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1983 >> Scrambler Base, 4.2 C, Standard, T4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Servicing - A/T) >> Adjustment >> Shift Linkage >> Cable Linkage

Cable Linkage

WARNING: This page is about a different car, the 1989 Jeep Wrangler, 1989 Jeep Wagoneer, 1989 Jeep Grand Wagoneer, 1989 Jeep Comanche, and 1989 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place gearshift lever in Park and raise vehicle. Using a small screwdriver, unlock shift control cable by releasing U-shaped cable adjuster clamp. Remove cable from mounting bracket.
  2. Move transmission shift lever rearward until fully seated into Park detent. Ensure that drive shaft cannot be rotated. Snap control cable into cable mounting bracket and replace U-shaped cable adjuster clamp.
  3. Lower vehicle and verify engine starting. Engine should start only with shifter in Park or Neutral.
scientia non olet · About LEMON Manuals