LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1983 >> Scrambler Base, 4.2 C, Standard, T4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Servicing - A/T) >> Adjustment >> Low-Reverse (Rear) Band >> Loadflite 727 & 999

Loadflite 727 & 999

WARNING: This page is about a different car, the 1989 Jeep Wrangler, 1989 Jeep Wagoneer, 1989 Jeep Grand Wagoneer, 1989 Jeep Comanche, and 1989 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support vehicle. Drain transmission fluid and remove oil pan. Locate low-reverse band adjusting screw on rear servo lever. See Fig 1. Loosen adjusting screw lock nut and back off approximately 5 turns.
  2. Tighten adjusting screw to 72 INCH lbs. (8 N.m). Back off adjusting screw 4 turns. Hold adjusting screw and tighten lock nut to 25 ft. lbs. (34 N.m). Install oil pan and fill transmission with fluid.
Fig 1: Adjusting Low-Reverse (Rear) Band
G121179Courtesy of CHRYSLER LLC
scientia non olet · About LEMON Manuals