LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1983 >> Scrambler Base, 4.2 C, Standard, T4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Servicing - A/T) >> Adjustment >> Transmission Throttle Cable/Linkage >> 904 Transmission with 6-Cylinder Engine

904 Transmission with 6-Cylinder Engine

WARNING: This page is about a different car, the 1988 Jeep Wrangler, 1988 Jeep Wagoneer, 1988 Jeep Grand Wagoneer, 1988 Jeep Comanche, and 1988 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove air cleaner. Hold throttle control lever rearward against its stop. Block choke plate open and set carburetor linkage completely off fast idle cam.
  2. Unlock throttle control cable by lifting "T" shaped adjuster clamp with small screwdriver. Move cable outer sheath forward to remove any cable load on throttle cable bellcrank.
  3. Adjust cable by moving cable and sheath rearward until there is no lash between cable and throttle linkage. Lock cable by pressing "T" shaped clamp downward until clamp snaps into place. Install and reconnect any parts removed and/or disconnected.
scientia non olet · About LEMON Manuals