LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1983 >> Scrambler Base, 4.2 C, Standard, T4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Servicing - A/T) >> Adjustment >> Transmission Throttle Cable/Linkage >> 727 Transmission with 6-Cylinder Engines

727 Transmission with 6-Cylinder Engines

WARNING: This page is about a different car, the 1988 Jeep Wrangler, 1988 Jeep Wagoneer, 1988 Jeep Grand Wagoneer, 1988 Jeep Comanche, and 1988 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect throttle control rod spring. Use spring to hold transmission throttle control lever forward, against stop. Block choke open and release fast idle cam.
  2. On carburetors equipped with throttle operated solenoid valve, turn key to "ON" position to energize solenoid. Open throttle halfway to allow solenoid to lock. Return throttle to idle position.
  3. Loosen retaining bolt on throttle control adjusting link. DO NOT  remove spring clip or nylon washer. Pull on end of link to eliminate lash. Tighten link retaining bolt. Reconnect throttle control rod spring.
scientia non olet · About LEMON Manuals