LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1983 >> Scrambler Base, 4.2 C, Standard, T4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Servicing - A/T) >> Adjustment >> Shift Linkage >> Rod Linkage

Rod Linkage

WARNING: This page is about a different car, the 1988 Jeep Wrangler, 1988 Jeep Wagoneer, 1988 Jeep Grand Wagoneer, 1988 Jeep Comanche, and 1988 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Loosen shift rod trunnion jam nuts at transmission lever. Remove shift rod-to-bellcrank lock pin. Disengage trunnion and shift rod. Place selector lever in "P" position and lock steering column. Move transmission shift lever to full rear Park position.
  2. Adjust shift rod trunnion to obtain free pin fit in bellcrank arm. Tighten jam nuts. On vehicles with shift lever on column, make sure linkage lash is eliminated by pulling down on shift rod and pushing up on outer bellcrank when tightening jam nuts.
  3. Check steering column lock for ease of operation. Ensure engine starts in "N" or "P", only. If starter engages in any drive gear, or does not work in "N" or "P", check for proper shift linkage adjustment or faulty neutral safety switch.
scientia non olet · About LEMON Manuals