LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1983 >> Scrambler Base, 4.2 C, Standard, T4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Servicing - A/T) >> Adjustment >> Low-Reverse (Rear) Band

Low-Reverse (Rear) Band

WARNING: This page is about a different car, the 1988 Jeep Wrangler, 1988 Jeep Wagoneer, 1988 Jeep Grand Wagoneer, 1988 Jeep Comanche, and 1988 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise vehicle, drain transmission fluid and remove oil pan. Locate adjusting screw on rear servo lever. Loosen adjusting screw lock nut and back off about 5 turns.
  2. Tighten screw to 41 INCH lbs. (4.6 N.m) and back off screw at indicated number of turns. See LOW-REVERSE (REAR) BAND ADJUSTMENT. Hold adjusting screw in position and tighten lock nut to 35 ft. lbs. (48 N.m). Install oil pan and fill transmission with fluid.
    LOW-REVERSE (REAR) BAND ADJUSTMENT

    Application Tighten Screw to INCH lbs. (N.m) Back Off Screw
    Model 727 41 (4.6 N.m) 2 Turns
    Model 904 41 (4.6 N.m) 7 Turns
    Model 999 41 (4.6 N.m) 4 Turns
scientia non olet · About LEMON Manuals