LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1983 >> Scrambler Base, 4.2 C, Standard, T4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Servicing - A/T) >> Adjustment >> KICKDOWN (Front) Band

KICKDOWN (Front) Band

WARNING: This page is about a different car, the 1988 Jeep Wrangler, 1988 Jeep Wagoneer, 1988 Jeep Grand Wagoneer, 1988 Jeep Comanche, and 1988 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Locate kickdown band adjusting screw on left side of case (near throttle lever shaft). Loosen adjusting screw lock nut and back off approximately 5 turns. Ensure adjusting screw turns freely in case.
  2. Using Adapter (J-24063) and 5/16" square socket, tighten screw to 36 INCH lbs. (4 N.m). If adapter is not used, tighten screw to 72 INCH lbs. (8 N.m). Back off adjusting screw. See KICKDOWN (FRONT) BAND ADJUSTMENT. Hold adjusting screw in position and tighten lock nut to 35 ft. lbs. (48 N.m).
    KICKDOWN (FRONT) BAND ADJUSTMENT

    Application (1) Back Off Screw
    All Models 2 1/2 Turns
    (1)
    Tighten screw to 72 INCH lbs. (8 N.m) and back off indicated number of turns.
scientia non olet · About LEMON Manuals